Skip to main content

Pay Increase

Depending on the volume of changes and your organizational structure, Belina Payroll provides four methods for applying a pay increase.


Method 1: Manual Pay Increase​

Use this method for ad-hoc changes or when only a few individuals require an updated rate.

image

  • Go to Edit → Employee Master.
  • Select the specific employee whose rate is changing.
  • Click the 'Pay' tab.
  • (Multi-currency): Click the ellipsis ... button next to the 'Rate of Pay' field and make the necessary changes.
  • (Single currency): Directly change the figure in the 'Rate of Pay' field.
  • Press Close, then press OK on the employee record to save the changes.

Method 2: Pay Increase Module​

This utility applies a bulk percentage or fixed amount increase to the entire payroll, specific departments, or tagged individuals. Crucial: Always perform a  backup before using this module so you can safely revert if necessary.


View written instructions

Step 1: Setup Parameters​

image

  • Go to Utilities → Pay Increase.
  • Choose your base tab: Employee Masterfile or NEC / Internal Grade.
  • Select the adjustment type:

image

Parameter / FieldDescription
PercentageChange the rate(s) of pay by a specified percentage.
Set Period AmountChange the rate(s) of pay to a specified amount.
Adjust Current RateChange the rate(s) of pay by a specified amount.
Base Rates on PeriodBase the increase on rates of pay that applied in a specified prior period.
Input Value (Percentage / Period Rate / Amount)The prompt for this field changes based on your selection above. Enter the specific percentage change, the exact rate of pay, or the adjustment amount accordingly.
Round MethodSelect the required rounding method (based on your Coinage setup):• None: No rounding required.• Nearest: .50 and above rounds up, while 0.49 and below rounds down.• Off/Up: Always round up to the nearest number.• Off/Down: Always round down to the nearest number.
DenominationUse the drop-down menu to select the rounding denomination. Selections available are taken from what has been set up on the Coinage table.
  • Enter the applicable percentage or amount.

  • Select your rounding method and denomination (based on your Coinage setup).

Step 2: Compute and Verify​

  • Click 'Options' to filter the target employees (by department, cost centre, or tagged individuals).
  • Click 'Compute' to calculate the new rates based on your parameters.
  • Click 'Enquiry' to view the results in a table.
  • Verification: If the figures are incorrect, press 'Clear file' to discard the calculation and start again. You can also press 'Report' to print a hard copy for verification.

Step 3: Update​

  • Once thoroughly verified, press 'Apply New Rates'. This permanently locks the new rates into the affected Employee Masterfiles.

image


Method 3: Grade Rate Change​

Use this method if your organization strictly standardizes pay using grade tables.

  • Go to Edit → Organizational, then select either 'Internal Grade' or 'NEC Grade'.
  • Manually change the standard grade rate. This change will automatically cascade to all employees assigned to that grade.

Method 4: Excel Import​

Use this option if you prefer computing complex revised pay rates in an external spreadsheet before bringing the finalized figures into the system.

  • Calculate the new rates in Microsoft Excel.
  • Import the finalized rates directly into the Employee Master using the standard Spreadsheet Import facilities.

Was this page helpful?